Inductive sensor PFI25-8DP, flat 25 mm, Sn=8mm, PNP NO, 2 m PVC cable, IP67

PFI25-8DP is an Autonics flat-type inductive sensor with a 25 mm sensing face on the top side and an 8 mm sensing distance. The PNP output is normally open (NO); a red LED shows the operating state.

• Sensing distance: 8 mm, setting distance 0...5.6 mm; standard target 25 x 25 x 1 mm iron, hysteresis ≤ 10 %
• Output: PNP, NO; up to 200 mA, residual voltage ≤ 1.5 V; response frequency 200 Hz
• Supply: 12-24 VDC (operating range 10...30 VDC), 3-wire, current consumption ≤ 10 mA
• Protection: surge, reverse polarity, output short circuit and overcurrent
• Housing: PPS, sensing face on the top side; 2 x M3 bolts included
• Environment: IP67, operating temperature -25...+70 °C, humidity 35...95 % RH
• Connection: 2 m PVC cable, Ø 4 mm, 3 cores AWG 22

Two sensors side by side need at least 80 mm between them, face to face at least 100 mm, to avoid mutual interference. Tighten the M3 mounting screws to no more than 1.47 Nm.